Connecting Water Supply Hose - ECOSTAR WM08-700 Owner's Instruction Manual

Connecting Water Supply Hose

Before connecting the Water Supply Hose to the water tap, check the hose type and choose the correct instruction
here under.
Note that the Water Supply Hose supplied may vary from country to country, Make sure to connect the blue inlet
hose to the COLS water tap, and the orange inlet hose to the HOT water tap.
Connecting Water Supply Hose to water tape
Normal Type
Untighten the screw
Untighten the screw of the connector so that the tap
can be placed in the middle
Fixing the connector to the tap
Push the upper connector up till the rubber packing is
in tight contact with the tap, then tighten the 4 screws.
Attach the water supply hose securely to
the connector
Push the water supply hose vertically upwards so that the rubber
seal within the hose can adhere completely to the tap
Fixing the connector to the water supply hose
Attach the water supply hose to the connector and then tighten it
by screwing it to the right
Check the connection of water supply hose and the connector
After connecting the hose, open the tap to check for any water
leakage.
If the water leaks, close the tap and start again from step 1.
The washing machine is to be connected to the water mains using new hose-sets and old hose sets should
not be reused.
(Normal tap without thread & screw type inlet hose)
15
Rubber Packing
Screw
Connector
Connector
Water Supply Hose