Troubleshooting - ECOSTAR WM08-700 Owner's Instruction Manual

Troubleshooting

When the washer is in trouble, please contact authorized EcoStar Service Center. Customer should not dismantle
the machine without permission.
List of faults and inspection
If the washer can not work normally, or appear abnormity or alarms, please check and correct as follows.
Faults
No Water
Flows In
No Washing
Abnormal Draining
Abnormal Spin
Note: During the de spin process, if washing are piled at one side of the spin barrel, it will cause unbalance of spin
barrel resulting in striking. At this moment, the computer inside the washer will feel this unbalance phenomenon and
will automatically correct it ( fill in water Washing ). However, if unbalance situation is not removed after continuous three
corrections, which means the computer auto-correction can not resolve the problem. Then the user has to manually and
evenly place the clothing inside the barrel to solve the problem.
If the power is off or the fuse is burnt out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic sound is normal
phenomenon when the inlet valve is switched on)
If the "Start / Pause" button is pressed after the power switch is pressed.
If the power is off or the fuse is burnt out.
If the power supply voltage is too low.
If the water amount reaches to the required water level. (The washer will not work if the water
amount does not reach the required water level)
If it is set to "Delay" washing mode. (It will only start to work until the reservation time
reached)
If the water drain hose is placed very high.
If the end of water drain hose is sealed in pond.
If the internal rubber ring of drain valve is blocked by dirt.
If the door lid is closed.
If all clothing piled largely at one side of barrel or the clothing is excessively placed.
If the washer is not placed in stable condition or it is placed in inclination state. (The ground
is not flat).
If the motor belt is loosened.
Inspection Items
21