Lighting Area Adjustment - Panasonic PT-FW100NTU Service Manual

8. After the adjustment, reassemble the projector according to the steps 8 through 9 in the section 7.19. "Replacement of LCD
Panel (B)".
8.5.

Lighting Area Adjustment

8.5.1. Tools to be used
Service Kit: This kit is composed of 3 extension flexible cables.
Note:
· Consult your dealer or Authorized Service Center for the service kit.
8.5.2. Preparation
1. Remove the upper case and the connector cover according to the steps 1 and 2 in the section 7.3. "Removal of A-P.C.Board".
2. Unscrew the 3 screws.
3. Disconnect the connector between L-P.C.Board and A-P.C.Board (A26).
4. Connect the service kit (extension flexible cables).
· Each flexible cable of LCD Panels (R/G/B) - Connectors (A1/A2/A3) on A-P.C.Board
5. Covering with an insulator (cloth or the like) to prevent a short circuit, set the A-P.C.Board block on the main unit.
Note:
· Handle with care not to apply external force to connecting parts which connect the main unit and A-P.C.Board.
Repeat steps (1) to (3) until the green and blue crosshatch
patterns merge into a cyan pattern.
25
PT-FW100NTU / PT-FW100NTE / PT-FW100NTEA