Using The Serial Connector; Connection; Pin Layout And Signal Names For Serial Connector; Communication Settings - Panasonic PT-FW100NTU Service Manual

6 Using the SERIAL Connector

The serial connector which is on the back connector panel of the projector conforms to RS-232C standard. This projector can
be controlled by a PC which is connected as shown in "6.1. Connection".
For controlling this projector by a PC, requires communication software on the market, and inputs control commands according
to Communication Settings and Control Commands below.
6.1.

Connection

Note:
Use a proper communication cable which is suitable for the PC to connect SERIAL connector and the PC.
6.2.

Pin Layout and Signal Names for SERIAL Connector

6.3.

Communication Settings

Signal Level
Sync. method
Baud rate
Parity
Character length
Stop bit
X parameter
S parameter
Pin No
Contents
Asynchronous
Conforms to 9 600 bps
RS-232C None
standard 8 bits
1 bit
Not used
Not used
11
PT-FW100NTU / PT-FW100NTE / PT-FW100NTEA
Signal Name
1 ---
2 TXD
3 RXD
4 ---
5 GND
6 DSR
7 CTS Connected internally
8 RTS
9 ---
Description
Synchronizes every 1 character (8 bits)
Data transfer speed
Error detection method
Number of bit composing 1 character
Uses stop bit when asynchronous method
Contents
NC
Transmit data
Receive data
NC
Ground
NC