Canceling The Self-Check Mode; Test Pattern; Procedure To Display Test Patterns; Canceling The Test Pattern Display - Panasonic PT-FW100NTU Service Manual

PT-FW100NTU / PT-FW100NTE / PT-FW100NTEA
3.3.

Canceling the self-check mode

Press "MENU" button on the main unit or remote control unit.

4 Test Pattern

This projector displays seven kinds of test patterns [Horizontal lines, Vertical lines, Dots, Crosshatch, White cross, Black cross and
White (No pattern)] in the four colors (White, Red, Green and Blue).
Note:
· Because the above patterns can be displayed by each color without test equipment such as PC or SG, use it for simplified
adjustments by your eyes and so on.
4.1.

Procedure to display test patterns

Select "TEST PATTERN" on "EXT OPTION" menu and press "ENTER" button on the main unit or remote control unit.
Note:
· On the test pattern screen, pressing the up-arrow "
the left-arrow "
4.2.

Canceling the test pattern display

Press "MENU" button on the main unit or remote control unit.

5 Flicker Adjustment Mode

If replacing the optical parts (LCD Panel / LCD block) of this projector and/or A-P.C.Board (assembly), enter the flicker adjustment
mode and minimize the flicker.
5.1.

Procedure to enter the adjustment mode

Select "FLICKER ADJUST" on "EXT OPTION" menu and press "ENTER" button on the main unit or remote control unit.
Note:
"DESK setting (blue)" is displayed when entering the adjustment mode.
5.2.

Adjustment Display and Contents

· Setting value is increased and decreased with the right-arrow "
" ": Decrease, "
− − − − Adjust the setting value to minimize the flicker on the screen.
− − − − Execute the adjustment by 6 patterns below.
· The pattern (adjustment display) is switched with the up-arrow "
" ": Forward direction, "
− − − − There are 6 patterns of "DESK setting (blue)", "DESK setting (red)", "DESK setting (green)", "CEILING setting (blue)",
"CEILING setting (red)" and "CEILING setting (green)".
− − − − The setting value is saved into this projector when the pattern is switched.
5.3.

Canceling the flicker adjustment mode

Press "MENU" button on the main unit or remote control unit.
Note:
When "MENU" button is pressed, the setting value at that time is saved into this projector and the adjustment mode is canceled.
" or right-arrow " " button the color selection (White / Red / Green / Blue).
": Increase
": Reverse direction
" or down-arrow " " button allows the test pattern selection and
" and left-arrow "
" and down-arrow "
10
" buttons.
" buttons.