Pairing The Remote And Stereo; Audio Settings - Jacuzzi J-375 Owner's Manual

WARNING:
EXISTS AND EQUIPMENT DAMAGE! Never install or
remove electrical devices (e.g. Apple device/MP3/USB/AUX/
Bluetooth) while hands are wet or while sitting partially or fully
immersed in the spa!
CAUTION: Never leave electrical devices in the Media Locker
when spa is not is use to prevent damage from outdoor ele-
ments! Never spray Media Locker with a pressurized water
hose for any reason! Damage to the device or spa stereo
system caused by water intrusion is not covered under the
manufacturer's warranty! Damage to Media Locker port or
electrical devices due to excessive force or improper align-
ment during installation or removal from Media Locker is not
covered under warranty.
18.1

Pairing the Remote and Stereo

In order for the remote to operate the stereo, you
need to pair them using the following method:
1. Make sure the stereo unit is in "Standby" mode.
LED power light will be red, Figure A.
2. Press any button on the remote to turn it ON.
The remote LCD display will read "No Link."
3. Press and hold the "Mode" button on the remote (Figure B).
At the same time, press and hold the power button on the
stereo for 2 seconds (Figure A).
4. The remote LCD display will read "Welcome," "Load" and
"Radio" if the pairing sequence was successful.
18.2

Audio Settings

The Audio button, Figure C, provides access to many of the ste-
reo's settings. By continually pressing the Audio button you can
scroll and adjust the following functions: BAS-TRE-BAL-FAD-
DSP-AREA-LOUD-DX-STEREO (respectively).
Note: You can adjust the settings by pressing the Audio button,
making your adjustments and pressing the Audio button to go
the next feature. If you exit the setting menus continually press
the Audio button until you reach the setting you would like to
adjust.
1. Bass Setting: Press the Audio button once to access the
bass setting. The LCD display will change to "BAS 0,"
Figure D. Press the Up button to adjust the setting to a
maximum of +5. Press the Down button to adjust the setting
down to -5.
Note: The default setting is "0." This feature is disabled when a "Digital
Sound Processor" (DSP) setting is active such as "Rock," "Classic," or
"Pop."
RISK OF ELECTRICAL SHOCK HAZARD
J-300
Figure A
AUDIO MODE
1 2 3
DIR - REPEAT DIR + RANDOM
Figure B
AUDIO MODE
1 2 3
DIR - REPEAT DIR + RANDOM
Figure C
Figure D
67