Britax MULTI-TECH II User Instructions page 29

4f
4h
3
1
4
4i
2
1
4j
100° 80°
4g
Loop the end of the loops of the fastening belts around the seat in front and
back again, as illustrated
toward the outside of the vehicle seat and guide them through the loops
Guide the tightening ends under the seat. When the support leg brackets
are pointing to the front and the belts are not twisted, lock the buckle of the
fastening belt into the tongues on the sides of the child seat
fastening belts by pulling the loose ends downwards evenly
2
Pull the support leg as far away from the back of the child seat as possible
1 (Fig. 4i). Lower the support leg as far as the floor, maintaining the correct
angle 2 . Move the support leg and ensure that the support leg is secured.
Finally, ensure that the fastening belts are fully tightened, by pulling down
on the loose ends
and not on the flaps of storage compartments or similar, at an angle of 100°
to the horizontal
operating instructions, in order to check the angle of the support leg against
the floor.
Check whether the child seat is firmly installed by moving it back and forth,as
well as sideways. If it is loose or if the support leg is not at an angle of 100° to
the floor, you will need to reinstall it, so that it is secured at the correct angle.
Put your child into the seat according to
Lay the fastening belt around the
passenger seat as illustrated in
If your car has an eyelet in the glide rail
of the set, this can alternatively be used
(Insert in Fig.
IMPORTANT
fastening belts with luggage straps.
1 (Fig. 4h). Put the ends of the fastening belt
(Fig. 4j). The support leg must be resting on solid ground
(Fig. 4j). Use the angle measurer on the last page of these
Fig.
9-25kg
4g).
– Do not install the
. Tighten the
3
.
4
5f.
(Fig. 4f).
2 .