Britax MULTI-TECH II User Instructions page 28

4. Installation of your child seat (positioned backward) in a front
seat
4a
4b
4d
4e
IMPORTANT – The child seat MUST always be used with a lap belt and diagonal belt
(approved according to UN/ECE Directive No. 16 or relevant standards).
IMPORTANT – Do not use any carrying points other than those described in these
operating instructions and those labelled in the child restraint equipment.
NEVER
install a child seat backwards on a vehicle seat that is equipped with an
airbag.
Slide the front seat back in order to create space for the child seat, but only so far
that the passenger sitting behind it can still sit comfortably.
Place the child seat with the support leg in the shortest position backwards on the vehicle
seat, so that the rocking base is lying against the back of the car seat.
4c
Push the belt through the belt tunnel, attach it on the other side and put the
tongue into the buckle
Pull the loose seatbelt through the child seat, in order to ensure that the
seatbelt is not twisted. When the belt is tight, close the buckle on the side of the
belt buckle and ensure that the lap belt and diagonal belt are secured
in Fig. 4d).
Close the belt buckle on the other side and ensure that only the lap belt is
secured (Fig. 4d).
Ensure that both belt buckles have locked in.
If the belt buckle is no in the position that is market with a
the seat cannot be correctly fastened
car.
IMPORTANT
the dashboard or on the wind screen.
Open both buckles. Pull the lap and diagonal
harness out sufficiently
900 mm). Put the belt through the belt buckle
guide on the opposite side of the buckle and
into the belt tunnel
access slots in the seat cover in order to
simplify the insertion of the belt through the
belt tunnel and under the seat cover
in Fig. 4b).
(Fig. 4c).
(Fig. 4e), try it on a different seat in the
(Fig. 4a).
– NEVER rest the child seat on
(approx. 600-
(Fig. 4b). There are two
(Insert
(Insert
as incorrect and