Utilitech 7111-04-L Instructions Manual page 7

NEW CONSTRUCTION ASSEMBLY INSTRUCTIONS
3. Place the fan housing next to a ceiling joist or
wall stud. The fan housing should be level and
perpendicular to the joist or stud.
4. Mount fan housing to the joist or stud by nailing where
indicated by arrows inside fan housing (4.1).
5. Pull wire through hole (5.1) and into junction box (not
included). Using quick connector, secure 120-volt AC
house wiring from wall switch to fan as shown in wiring
diagram on page 5.
Note: 12 AWG is the minimum conductor to be used for
branch-circuit wiring.
CAUTION: If your electrical wires do not match the
colors listed, you must determine what each house
wire represents before connecting. You may need to
consult an electrical contractor to determine safely.
3
4
5
7
Joist or
wall stud
4.1
Quick
connector
House
wires
Product
wires
5.2
Lowes.com
Joist or
wall stud
5.1