Stihl BG 50 Instruction Manual page 16

English
Pull the throttle trigger (2) and hold it
N
there.
Crank engine until it begins to fire.
N
Set the choke lever (3) to e.
N
Pull the throttle trigger (2) and hold it
N
there.
Continue cranking until the engine
N
runs.
If the engine is warm
Also use this setting if the engine has
been running but is still cold.
Set the choke lever (3) to e.
N
Pull the throttle trigger (2) and hold it
N
there.
Continue cranking until the engine
N
runs.
14
Cranking
Place the unit on the ground so that
N
it is secure.
Make sure you have a firm footing:
N
Hold the unit firmly with your left
hand on the housing and press
down.
Hold the starter grip with your right
N
hand.
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Stopping the Engine
Move the stop switch to 0
N
Other Hints on Starting
If the engine stops during warm-up or
acceleration
Repeat the starting procedure – see
N
"If the engine is cold".
If engine does not start
Make sure all settings are correct
N
(choke shutter, stop switch in run
position I).
Repeat the starting procedure.
N
If the engine still does not start
Move the stop switch to 0
N
Remove the spark plug – see
N
"Spark Plug".
Dry the spark plug.
N
Crank the engine several times with
N
the starter to clear the combustion
chamber.
Refit the spark plug – see "Spark
N
Plug".
Move the stop switch to I
N
set the choke lever to e – even if
N
the engine is cold.
Pull the throttle trigger (2) and hold it
N
there.
Now start the engine.
N
BG 50