Stihl BG 50 Instruction Manual page 15

3
Move the choke lever (3) to f.
N
Pull the throttle trigger (2) and hold it
N
there.
Continue cranking until the engine
N
runs.
Wait 10 seconds, then move the
N
choke lever (3) to e.
If the engine is warm
Also use this setting if the engine has
been running but is still cold.
Move the choke lever (3) to f.
N
Pull the throttle trigger (2) and hold it
N
there.
Continue cranking until the engine
N
runs.
Wait 10 seconds, then move the
N
choke lever (3) to e.
BG 50
Cranking
Place the unit on the ground so that
N
it is secure.
Make sure you have a firm footing:
N
Hold the unit firmly with your left
hand on the housing and press
down.
Hold the starter grip with your right
N
hand.
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Starting the Engine – Version B
Observe safety precautions.
N
Press the fuel pump bulb at least
N
five times – even if the bulb is
already filled with fuel.
1
2
Move the stop switch (1) to the run
N
position I
Setting the choke lever
If the engine is cold
3
Move the choke lever (3) to g
N
English
13