Advertisement
QuickSpecs
Standard Features
UPS and PDU Power
Cord Matrix
Server Power Cords
System Fans
Required Cabling
Operating Systems and
Virtualization Software
Support for ProLiant
Servers
Rack Airflow
Requirements
Please see the UPS and PDU cable matrix's on the HP Power Protection and Management page.
Under Power Cords, click on the "HP Power Cord Matrix" link. That link will list cable descriptions,
requirements, and specifications for UPS and PDU units. Please see the following link:
www.hp.com/products/powercords.
NOTE: The HP ProLiant DL785 G5 servers ship standard worldwide with a 6-foot IEC 320-C14 to
IEC320-C13 jumper cord. If you require a local power cord, please check the Power Specifications
below for the appropriate country-specific power cord, or consult the Power Cord Matrix:
http://www.hp.com/go/powercordmatrix.
Standard
Maximum
NOTE: Fans are N+1 hot plug redundant and individually removable.
For required cabling information, refer to the HP Web site at:
Microsoft Windows Server
Microsoft Windows Server Hyper V
Red Hat Enterprise Linux (RHEL)
SUSE Linux Enterprise Server (SLES)
Oracle Enterprise Linux (OEL)
Solaris
VMware
Citrix XenServer
NOTE: For more information on HP's Certified and Supported ProLiant Servers for OS and
Virtualization Software and latest listing of software drivers available for your server, please visit
our Support Matrix at:
http://www.hp.com/go/ossupport
www.hp.com/support/DL785G5.
Rack 10000 G2 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling
efficiency for rack-mounted servers. The 10000 G2 Series Racks provide enhanced airflow for
maximum cooling, allowing these racks to be fully loaded with servers using the latest processors.
CAUTION: If a third-party rack is used, observe the following additional requirements to ensure
adequate airflow and to prevent damage to the equipment:
Front and rear doors: If your 42U server rack includes closing front and rear doors, you
must allow 830 square inches (5,350 sq cm) of holes evenly distributed from top to bottom
to permit adequate airflow (equivalent to the required 64 percent open area for ventilation).
Side: The clearance between the installed rack component and the side panels of the rack
must be a minimum of 2.75 inches (7 cm).
CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack.
This arrangement ensures proper airflow. Using a rack without blanking panels results in improper
cooling that can lead to thermal damage.
NOTE: For additional information, refer to the Setup and Installation Guide or the Documentation
CD provided with the server, or to the server documentation located in the Support section at the
following URL: www.hp.com/servers/dl785.
DA - 13046
Worldwide QuickSpecs — Version 25 — 8/16/2010
6 Hot plug, redundant fans
6 Hot plug, redundant fans
HP ProLiant DL785 Generation 5
www.hp.com/servers/dl785
and our driver download page
Page 9
Advertisement
