Power Specifications For The Avaya Ethernet Routing Switch 4500 Series - Avaya 4500 Series Installation Manual

Installing the Avaya Ethernet Routing Switch
cannot operate with the switch. Consult the documentation provided with the USB drive to
ensure compliance with these standards.
Resetting the switch to the default configuration
The restore factory-default command resets the switch or stack to its default
configuration.
To reset the switch or stack to its default configuration perform the following procedure.
1. Enter restore factory-default.
2. Enter y to restore the switch to default.
The restore factory-default command is in the privileged exec command mode.
For more information on USB ASCII Config Support, refer to the Avaya Ethernet Routing Switch
4500 Series Configuration — System (NN47205-500).
Power specifications for the Avaya Ethernet Routing Switch
4500 Series
This section describes power specifications for the switches in the 4500 Series.
For information specific to your switch, Avaya Ethernet Routing Switch 4500 Series—
Installation NN47205-300.
Note:
If you connect one type of Power over Ethernet switch to another, for example a 4548GT-
PWR and a 4550T-PWR, one switch may deliver power to the other. This is due to the PoE
Legacy Type Detection. Workaround: Legacy detection can be disabled on the switch if you
are not using any PoE devices which require legacy detection. An alternate solution is to
administratively disable Power over Ethernet on ports interconnecting any two Power over
Ethernet switches.
32 Installation
The following message appears:
Warning the switch/stack will be reset to factory default
configuration. Do you wish to continue (y/n) ?
Important:
If you enter restore factory-default [-y], the[-y] parameter instructs
the switch not to prompt for confirmation.
November 2010