Emission Control System - Husqvarna W436 Operator's Manual

Emission Control System

This equipment and/or its engine may include
exhaust and evaporative emissions control
system components required to meet U.S.
Environmental Protection Agency (EPA) and/
or California Air Resources Board (CARB)
regulations. Tampering with emission controls
and components by unauthorized personnel
may result in severe fines or penalties.
Emission controls and components can
only be adjusted by a Husqvarna dealer
or an authorized engine manufacturer's
service center. Contact a Husqvarna dealer
concerning emission controls and components.
General
In this operator's manual, left and right,
backward and forward are used in relation to
the machine's normal driving direction.
Transport on Public Roads
Check applicable road traffic regulations
before transporting on public roads. If the
machine is transported, you must always use
approved fastening equipment and ensure that
the machine is well anchored.
Operating
This machine is constructed only for mowing
grass on lawns and even ground without
obstacles such as stones or tree stumps.
All other types of uses are incorrect. The
manufacturer's directions concerning
operation, maintenance, and repairs must be
carefully followed.
Lawn mowers and all power equipment can
be potentially dangerous if used improperly.
Safety requires good judgement, careful use
in accordance with these instructions and
common sense.
The machine must only be operated,
maintained, and repaired by persons familiar
with the machine's special characteristics and
who are also knowledgeable about the safety
instructions. Use only approved repair parts to
maintain this machine.
Accident prevention regulations, other general
safety regulations, occupational safety rules,
and traffic regulations must be followed without
fail.
Unauthorized modifications to the design of
the machine may absolve the manufacturer
from liability for any resulting personal injury or
property damage.
- 4 -