Table of Contents
Advertisement
• The factory default values are zero for all Luminaires.
To program a Luminaire's default scene with the remote control unit:
1. Set the Luminaire to Remote Control mode (see previous section).
2. Press the
3. In RGBW Luminaires, use digits
4. Set LED intensity as follows:
5. When you have programmed the scene, press
An Exterior 50 & 100 Luminaire will display its default scene each time it is
powered on, unless it receives a DMX signal.
Setting up via RDM using Martin M-PC™
The Exterior 50 & 100 system is compatible with RDM (Remote Device
Management). Using an RDM-compliant DMX controller such as the
Martin M-PC™ Windows application, you can communicate with the
Luminaires on the data link via RDM. You can retrieve Luminaire data,
and you can also:
• Set the DMX addresses of all the Luminaires on the link
• Set Luminaires to raw or calibrated modes.
To use Martin M-PC, connect a PC running this application to the data link
using the Martin USB Duo™ USB/DMX interface box.
–
key to enter Scene Setting mode. The Luminaire
responds with one short flash (blue in RGBW Luminaires) and the
LEDs switch to the last stored scene. LEDs flash each time the
Luminaire accepts an entry for the rest of this procedure.
the individual LEDs:
•
selects Red
1
•
selects Green
2
•
selects Blue
3
•
selects White
4
•
Increases the intensity of the selected LEDs (in RGBW
Luminaires) or all LEDs
•
Decreases the intensity of the selected LEDs (in RGBW
Luminaires) or all LEDs
•
Sets all luminaires to zero intensity
•
Sets all luminaires to full intensity
scene in the Luminaire and exit Scene Setting Mode.
-
on the numeric keypad to select
1
4
Setup
to store the
Sign
67
Advertisement
Table of Contents
