Installing Luminaires; Physically Installing Luminaires - Martin Exterior 50 User Manual

Installing Luminaires

Using their supplied mounting brackets, Exterior 50 & 100 Luminaires can
be fastened to a flat surface, mounted on standard 35 mm top-hat section
DIN rail that is fastened to a flat surface, fastened to telescopic or fixed-
length mounting posts that are fastened to a flat surface, or fastened to a
ground stake that is embedded in the ground so that the stake will offer a
stable support.
Supporting surfaces, fasteners and hardware must be capable of
supporting ten times the load they will bear when devices are installed.

Physically installing Luminaires

Luminaires can be installed on a surface, on DIN rail or on a mounting
post (including a ground stake that is pushed into the ground to anchor it
securely)
Fastening to a surface
An Exterior 50 or 100 Luminaire can be mounted on a flat, stable surface
in any orientation by fastening its mounting bracket to the surface. See
Figure 24.
To fasten to a surface:
1. Check that the surface is flat and stable, and that the surface and all
2. Pass a steel M6 fastener that is suitable for the environment, grade
3. Adjust the Luminaire for correct orientation and tighten the fastener.
installation fasteners can support at least ten times the weight of all
devices and hardware they will bear.
8.8 minimum, through the centre hole in the Luminaire mounting
bracket and tighten loosely at first.
Installing Luminaires 49