Table of Contents
Advertisement
General information
Before you start installing the Exterior 50 & 100 system:
• Read the "Safety information" section starting on page 8 carefully.
• Read this "General information" section carefully to familiarize yourself
with system layout principles and installation procedure.
• Check that you have all the components you will need, including hybrid
cable for Splitters and PSUs that can be ordered from Martin™.
• Check that the local AC mains power voltage is within the range shown
on the PSU's serial number label.
• Make sure that you have a plan of the installation.
Components in the system
The Exterior 50 & 100 system includes four types of device:
• The Exterior 50™, an IP68-rated LED washlight Luminaire.
• The Exterior 100™, an IP68-rated LED washlight Luminaire.
• The Exterior 50 & 100 PSU, a Power Supply Unit in an IPX7-rated
housing that supplies the Exterior 50 & 100 system with 30 VDC power.
The PSU also relays DMX and RDM (Remote Device Management)
data from a controller console or PC running controller software to the
system.
• The Exterior 50 & 100 Splitter, a power/data splitter device housed in an
IP65-rated junction box. The junction box can be waterproofed to IP68
by applying a sealing compound available from Martin™. Splitters relay
30 VDC power as well as DMX and RDM data to Luminaires and other
Splitters.
All luminaires are available in RGBW, CW (cool white), NW (neutral white)
and WW (warm white) options. The Exterior 100 is available in narrow
and medium-angle options.
Hybrid (power and data) cable from Martin™ must be used to connect
PSUs and Splitters. Hybrid cable is ordered separately.
A range of accessories for the system is available from Martin™ (see
"Accessories" on page 79).
System power: general
The system is powered by connecting the Exterior 50 & 100 PSU to AC
mains power.
General information
13
Advertisement
Table of Contents
