Irc-6 Infrared Remote Control; Irc-6 Operation; Master/Slave Mode - Chauvet Led Shadow User Manual

IRC-6 Infrared
Remote
Control

IRC-6 Operation

Master/Slave
Mode
Page 12 of 16
The LED Shadow™ is compatible with the IRC-6 infrared remote control from Chauvet.
Make sure to point the IRC-6 directly at the receiver on the front of the product.
Auto Mode
To run Auto mode:
1. Press <AUTO> to activate Auto program 0.
2. Press <1> <5> to activate one of the other programs.
–
3. Use <+> or <–> to increase or decrease the program speed.
Sound-Active Mode
To turn on Sound-Active mode:
Press <SOUND> on the IRC-6.
Manual Control
To manually control the intensity level:
1. Press <MANUAL> or <UV> on the IRC-6.
2. Press <+> or <–> to increase or decrease the output level.
Strobe Mode
To activate Strobe mode:
1. Press <STROBE> on the IRC-6.
2. Press <+> or <–> to increase or decrease the strobe rate.
To deactivate the strobe, switch to another mode.
Black Out
To black out the LEDs:
Press <BLACK OUT> on the IRC-6.
This will turn off all the lights until the button is pressed again.
NOTE: The IRC will not respond to any inputs when Black Out is activated. If the remote
does not respond when a button is pressed, try pressing <BLACK OUT>. You
may have inadvertently activated Black Out.
All other buttons on the IRC-6 infrared remote control have no function with this
product.
The Master/Slave mode allows a single LED Shadow™ product (the "master") to control
the actions of one or more LED Shadow™ products (the "slaves") without the need of a
DMX controller. The master product will be set to operate in either Automatic mode,
Sound-Active mode, or with the IRC-6, while the slave products will be set to operate in
Slave mode. Once set and connected, the slave products will operate in unison with the
master product.
Configure the products as indicated below.
Slave products:
1. Press <MODE> until SLA shows on the display.
2. Press <ENTER> to accept. SLAV will show in the display.
3. Connect the DMX input of the first slave product to the DMX output of the master
product.
4. Connect the DMX input of the subsequent slave products to the DMX output of the
previous slave product.
5. Finish setting and connecting all the slave products.
Master product:
1. Set the master product to run in Auto mode, Sound-Active mode, or with the IRC-6.
2. Make the master product the first product in the DMX daisy chain.
• Configure all the slave products before connecting the master to the daisy
chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the master.
• Do not connect more than 31 slaves to the master.
LED Shadow™ User Manual Rev. 6