Configuration
(Standalone)
Auto Programs
Sound-Active
Manual Mode
Display Timeout
Test Mode
Reset
LED Shadow™ User Manual Rev. 6
Set the product in one of the standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To run an auto program, do the following:
1.
Press <MENU> repeatedly until Aut shows on the display.
2.
Press <ENTER> and Aut0–5 will show on the display.
3.
Use <UP> or <DOWN> to select the desired program.
4.
Press <ENTER> and S. 01–99 will show on the display.
5.
Use <UP> or <DOWN> to increase or decrease the program speed.
6.
Press <ENTER>.
To run the LED Shadow™ in sound-active mode, follow the instructions below:
1.
Press <MENU> repeatedly until Sou shows on the display.
2.
Press <ENTER>. Soud will show on the display.
3.
Turn the sensitivity knob until the product responds to the beat of the music.
In Sound-Active mode, the product will only respond to low frequencies of music
(bass and drums).
To run the LED Shadow™ in manual mode, follow the instructions below:
1.
Press <MENU> repeatedly until CoL shows on the display.
2.
Press <ENTER> and CoLo will show on the display.
3.
Press <ENTER> again and L.000–255 will show on the display.
4.
Use <UP> or <DOWN> to increase or decrease the dimmer value.
5.
Press <ENTER> and S. 0–8 will show on the display.
6.
Use <UP> or <DOWN> to increase or decrease the strobe rate.
7.
Press <ENTER>.
To turn the display timeout on or off, do the following:
1.
Press <MENU> until SYS shows on the display.
2.
Press <ENTER> and LEdS, tESt, or rESt will show on the display.
3.
Use <UP> or <DOWN> to select LEdS.
4.
Press <ENTER> and on or oFF will show on the display.
5.
Use <UP>or <DOWN> to select whether the display timeout should be on or oFF.
6.
Press <ENTER>.
To run a test of the LEDs, follow the instructions below:
1.
Press <MENU> until SYS shows on the display.
2.
Press <ENTER> and LEdS, tESt, or rESt will show on the display.
3.
Use <UP> or <DOWN> to select tESt.
4.
Press <ENTER>.
To reset the software of the LED Shadow™, do the following:
1.
Press <MENU> until SYS shows on the display.
2.
Press <ENTER> and LEdS, tESt, or rESt will show on the display.
3.
Use <UP> or <DOWN> to select rESt.
4.
Press <ENTER>.
Page 11 of 16