Platform/Transmission Assembly - GE HTW200ASK_WW Technical Service Manual

Mode Shifter Reinstallation
1.
transmission shaft.
2. Install the clutch spring.
3. Slide the clutch into the clutch level of the mode
shifter and slide the clutch onto the shaft. There
are guide pins on the bottom of the mode shifter
that go into locator holes on the platform.
4. Install the two 3/8 hex bolts and torque to 60 in.
pounds.
Clutch
Clutch
Spring
Flat
Washer

Platform/Transmission Assembly

The platform assembly not only houses the
transmission, but is used to mount the drive motor
and mode shifter. The transmission has planetary
gears inside to assist with the agitation and spin
cycles of the washer. It is one complete part with
the exception of the two harness mounting brackets
(some models have one harness mounting bracket)
and a motor splash guard.
Platform/Transmission Removal
1. Remove the impeller or agitator to access the
2. Remove the hub nut and Belleville washer. The
3. Lean the washer back or lay the washer on its
After all other components have been removed from
the platform assembly:
4. Cut the wire ties that support the main harness
5. Remove the 3/8 hex bolts securing the motor
Guide
Pins
Locator Holes
6. Remove the eight 3/8 hex bolts securing the
7. Pry the platform assembly away from the tub.
The tub seal is pressed onto the shaft. Prying
against the tub bottom to remove the platform
assembly may be necessary.
– 65 –
hub nut.
hub nut has reverse threads, and needs to be
turned clockwise to loosen.
side to access the bottom.
to the platform assembly.
shield and the harness brackets to the platform.
platform to the bottom of the tub.
Tub Seal
(Continued next page)