Consumer Help Indicator - GE HTW200ASK_WW Technical Service Manual

Cycle Options - Continued
F
Deep Fill
Select the Deep Fill feature for loads where extra water is needed.
Press the Deep Fill button once before starting the cycle to add an incremental amount of water to the wash load.
Holding the Deep Fill
To cancel the option if desired, press the Deep Fill button again.
NOTE: The Deep Fill
Auto Soak
automatically.
2nd Rinse
When using extra detergent or bleach to clean heavily soiled clothes, use the 2nd Rinse option to better remove
additional residues.
Extra Spin
2nd Rinse + Extra Spin
Provides both a second rinse and an extra spin.
Deep Rinse
Set this option to provide a deep rinse or when using fabric softener. This option may change other settings (e.g. Spin
may go to a higher setting) to maximize performance.
Your washer is equipped with Consumer Help Indicator (CHI). CHI is the way to communicate a simple remedy for some
situations that you can perform without the need to call for service. The chart below describes the helpful lights you may
Spin light blinking
Fill light (Water not
entering washer)
Lid Locked light
Redistribution
Operating Instructions

Consumer Help Indicator

If an out-of-balance condition is detected by the washer, the Spin light will blink during the
remaining portion of the cycle and will stay illuminated for a short time after cycle completion.
When this occurs, the washer is taking actions to correct the out-of-balance condition and
complete the cycle normally. In some cases, the washer may not be able to balance the load
and spin up to full speed. If you notice the load is more wet than normal at the end of the cycle,
redistribute the load evenly in the wash basket and run a Drain & Spin cycle.
Check your house water supply. Did you forget to turn on one or both supply valves after
installation or coming back from vacation? As soon as the message starts to scroll, the washer
will initiate a 4 minute lockout period. The washer controls won't respond/change during this
time. After the 4 minutes, you can begin your cycle again. If you try to bypass the lock-out period
by unplugging the washer, the 4 minute timer will start over again.
Lid Locked
not start another cycle until the lid is opened. Try opening, then closing the lid and starting a
new cycle. If the problem persists, call 800.GE.CARES (800.432.2737) for service.
– 21 –
Deep Fill button again and the water will stop.