Motor Compatibility; Tools Required; Suitable Environment And Enclosure; Suitable Mounting Location - ABB ACS550-01 User Manual

8

Motor Compatibility

The motor, drive, and supply power must be compatible:
Specification
Motor type
Nominal current
Nominal frequency
Voltage range

Tools Required

To install the ACS550 you need the following:
• Screwdrivers (as appropriate for the mounting hardware used)
• Wire stripper
• Tape measure
• Drill
• Mounting hardware: screws or nuts and bolts, four each. The type of hardware
depends on the mounting surface and the frame size:
R1...R4
R5
R6

Suitable Environment and Enclosure

Confirm that the site meets the environmental requirements. To prevent damage
prior to installation, store and transport the drive according to the environmental
requirements specified for storage and transportation. See "Ambient Conditions"
134.
page
Confirm that the enclosure is appropriate, based on the site contamination level:
• IP 21 / UL type 1 enclosure. The site must be free of airborne dust, corrosive
gases or liquids, and conductive contaminants such as condensation, carbon
dust, and metallic particles.

Suitable Mounting Location

Confirm that the mounting location meets the following constraints:
• The drive must be mounted vertically on a smooth, solid surface, and in a suitable
environment as defined above.
Installation
Motor
3-phase induction motor
0.2...2.0 * motor nominal
current I
hd
10...500 Hz
Motor is compatible with
the ACS550 voltage range.
Frame Size Mounting Hardware
M5
M6
M8
Verify
–
• Type code label on drive, entry for "Output I"
(current), or
• Type code on drive and rating table in
"Technical Data" on page 127.
–
208...240 V (for ACS550-X1-XXXX-2) or
380...480 V (for ACS550-X1-XXXX-4)
#10
1/4 in
5/16 in
ACS550 User's Manual
Reference
on