Procedure 3.2 - Information Display - Precor RBK 815 Service Manual

Procedure 3.2 - Information Display

Software version numbers are invaluable for tracking and identifying problems and
staying aware of changes to the operation and features of the product.
Procedure
The information display will access the following data;
• Odometer
• Hour Meter
• U-Boot Software
• U-Base Software
• Lower Software
• Serial Number
• Usage log
• Error Log
Procedure
1. Pedal the bicycle or install an optional external power supply.
2. With the PRECOR banner scrolling, press the keys RESET,6,5, sequentially.
3. DIAGS-INFORMATION DISPLAY will scroll across the display.
4. Use the , keys to move to the desired display shown in the list above.
p q
5. ODOMETER display. Press the OK key.
6. The odometer will be displayed as XXX miles.
Note: The odometer data is stored in non-volatile memory on the upper PCA. If the
upper PCA is replaced the odometer data will be lost.
7. Press the CLEAR key to exit the odometer display.
8. HOUR METER display. Press the OK key.
9. The operating time of the unit will be displayed as 12345 HOURS. The operating
time is defined as total amount of time that the unit has operated in program
modes with the drive motor running. The hour meter is also used to provide the
"time stamp" for the error code log.
10. Press the CLEAR key to exit the hour meter display.
RBK 815 Recumbent Cycle
Page 10