JetCat P80 Instruction Manual page 38

Lrn Speed Lo
Lrn Speed Hi
LIN-Speed Ctrl
3-StepSpdCtrl
Reminder:
The turbine can be immediately switched off, any time the throttle stick and the throttle trim are
brought to their minimum positions.
If Hold-Speed or Cruise Control modes are activated, while the model is flying over 40 km/h --
and should the model then slow down, to a speed less than 40 km/h -- Hold-Speed or Cruise
Control will remain active. The turbine will NOT shut off, unless the AUX switch is moved
back to the SW1 position and then returned to Hold-Speed or Cruise Control position.
WARNING:
Make sure the Airspeed Sensor is working, before using features that require a minimum flight
speed to operate. If the system is not operating properly, you may inadvertently shut off your
engine, in flight. To verify that the Airspeed Sensor is functioning, apply a little air pressure
and note the change in "Airspeed" on the run menu display.
Learns the slow flight speed.
If the AUX switch is momentarily placed in the SW0 position, the current
flight speed is assigned and recorded as the Min.AirSpeed parameter.
WARNING: When the AUX switch is set in the SW0 position, the model
must be flying faster than 40 km/h, otherwise the turbine will shut off.
Learn the fast flight speed.
If the AUX switch is momentarily placed in the SW0 position, the current
flight speed is assigned and recorded as the Max.AirSpeed parameter.
WARNING: When the AUX switch is set in the SW0 position, the model
must be flying faster than 40 km/h, otherwise the turbine will shut off.
Cruise Control mode, with linear speed regulation to the throttle stick
position.
Flight speed is controlled between the values of the "Min AirSpeed"
(throttle stick in the minimum position) and "Max AirSpeed" (throttle stick
in the maximum position).
Cruise Control mode, featuring three different speeds.
Flight speed can be set to three predetermined speeds, between the
values of "Min AirSpeed" (throttle stick in the minimum position) and "Max
AirSpeed" (throttle stick in the maximum position).
Speed 1: "Min AirSpeed" à throttle stick in the minimum to 1/3
Speed 2: ("Min AirSpeed" + "Max AirSpeed") / 2 à throttle stick in the
rd
1/3 to 2/3
Speed 3: "Max AirSpeed" à throttle stick in the 2/3
position
Page 38/39
rd
position
rd
position
rd
to maximum