JetCat P80 Instruction Manual page 17

The GSU display will read:
Set AuxChan. to
CENTER:
- learn RC -
9. Set the AUX channel to the middle position for Start/Standby and press Select
Menu or the LED I/O board switch again, to store the R/C system's pulse width for
the turbine to start and run. The red Pump running LED will turn off and the yellow
Standby/Manual LED will illuminate. This indicates that the turbine start/standby
data has been set correctly.
The GSU display will read:
Set AuxChan. to
MAXIMUM:
- learn RC -
10. Place the AUX channel on the maximum position for Auto-Off and press Select
Menu or the LED I/O board switch, to store the R/C system's pulse width for a
normal shut-off of the engine. The yellow Standby/Manual LED will turn off and the
ECU will now permanently store the data. This indicates that the "learn R/C"
procedure is completed and the ECU now retains the pre-set stick position values.
Repeating this procedure is only necessary when the R/C system is changed or
adjusted.
à AUX channel middle "Start/Standby" position
à AUX channel maximum "Auto-Off" position
Page 17/39