Removing The Hard Disk Drive; Hard Disk Disassembly Process - Clevo N150RF1 Service Manual

Disassembly

Removing the Hard Disk Drive

Figure 2
The hard disk drive can be taken out to accommodate other 2.5" serial (SATA) hard disk drives with a height of 9.5mm
HDD Assembly
or 7mm (h). Follow your operating system's installation instructions, and install all necessary drivers and utilities (as
Removal
outlined in Chapter 4 of the User's Manual) when setting up a new hard disk.
a. Remove the SD cover

Hard Disk Disassembly Process

and screws.
b. Remove the bottom
1. Turn off the computer, remove the battery
case.
2. Remove the SD card cover
c. Locate the HDD.
3. Carefully lift the bottom case
4. The HDD will be visible at point
a.
c.

1. SD Card Cover
16. Bottom Case
• 14 Screws
2 - 6 Removing the Hard Disk Drive
and screws
1
6
up at point
16
on the mainboard
19
2
3
4
12
13
11
1
14
10
9
19
(page 2 - 5) and keyboard (page 2 -
- (Figure 2a ) .
2 15
and slide in the direction of the arrow
17
)
(Figure 2a .
b.
5
15
6
8
7
16
11).
to remove it (Figure 1b
18
18
16
17
) .