Clevo N150RF1 Service Manual page 14

Disassembly
8. Remove screws
Figure 4
9. Separate the hard disk
HDD Assembly
10. Reverse the process to install a new hard disk (do not forget to insert the mylar cover between the bracket and
Removal (cont'd.)
hard disk as shown before replacing the screws).
f. Remove the screws from
f.
the HDD assembly.
g. Separate the HDD, my-
lar cover and bracket.
g.

30. HDD
31. Bracket
32. Mylar Cover
• 5 Screws
2 - 8 Removing the Hard Disk Drive
- from the hard disk assembly
25 29
from the bracket
30
26 27
31
30
(Figure 4f ) .
and mylar cover (Figure 4g
31 32
25
28 29
Note that the hard disks pictured on the following pages
are all 9.5mm(h) hard disk drive.
In some cases, a 7.0mm(h) hard disk drive will be in-
stalled. Do pay attention on the alignment of the hard
disk and bracket when tightening the screws.
For more information, contact your distributor/supplier,
and bear in mind your warranty terms.
32
) .

Installing 9.5mm or 7mm HDD