Removing The M.2 Ssd Module - Clevo N150RF1 Service Manual

Removing the M.2 SSD Module

1. Turn off the computer, remove the battery
2. The M.2 SSD module will be visible at point
3. Remove the screw (Figure
2
4. The M.2 SSD module (Figure
3
5. Reverse the process to install a new SSD (make sure that the hexagonal screw is in the correct location). Note that
a flat-head screw driver can be used to tighten or remove the hexagonal screw as shown
a.
1
b.
(page 2 - 5), and bottom case
on the mainboard
1
9b)
9c) will pop-up, and you can remove it from the computer.
c.
3
2
(page 2 - 6).
(Figure 9a).
(Figure 9d).
3
Removing the M.2 SSD Module 2 - 13
Disassembly
Figure 9
M.2 SSD Module
Removal
a. Locate the M.2 SSD.
b. Remove the screw.
c. The M.2 SSD module
will pop up.

3.M2 SSD Module
• 1 Screw