Mercedes-Benz S-CLASS 2017 Operator's Manual page 63

The securing systems of child restraint systems
are:
the seat belt system
R
the LATCH-type (ISOFIX) securing rings
R
the Top Tether anchorages
R
If it is absolutely necessary to carry a child on
the front-passenger seat, be sure to observe the
information on the "Occupant Classification
System (OCS)" ( page 51). There you will also
Y
find information on deactivating the front-
passenger front air bag.
All child restraint systems must meet the fol-
lowing standards:
U.S. Federal Motor Vehicle Safety Standards
R
213 and 225
Canadian Motor Vehicle Safety Standards
R
213 and 210.2
Confirmation that the child restraint system cor-
responds to the standards can be found on an
instruction label on the child restraint system.
This confirmation can also be found in the instal-
lation instructions that are included with the
child restraint system.
Observe the warning labels in the vehicle inte-
rior and on the child restraint system.
Vehicles with seat belt extenders: when
securing a child in a child restraint system on a
rear seat, observe the following instructions:
make sure that the seat belt on the child
R
restraint system is fastened according to the
manufacturer's installation instructions for
the child restraint system.
for child restraint systems with a belt clamp:
R
engage the belt tongue in the buckle before
you tighten the seat belt using the belt clamp.
Vehicles with a rear reclining seat: when
installing a child restraint system, move the rear
reclining seat backrest to an almost vertical
position. The rear reclining seat backrest must
rest against the child restraint system. Observe
the notes on the cushion air bag (
Vehicles with belt bags: only use a child
restraint system which has been approved by
Mercedes-Benz. Always observe the instruc-
tions and safety notes on belt bags for the outer
seat belts in the rear (
page 50).
Y
page 46).
Y
Children in the vehicle
LATCH-type (ISOFIX) child seat secur-
ing system
G
WARNING
LATCH-type (ISOFIX) child restraint systems
do not offer sufficient protective effect for
children whose weight is greater than 48 lbs
(22 kg) who are secured using the safety belt
integrated in the child restraint system. In the
event of an accident, a child might not be
restrained correctly. This poses an increased
risk of injury or even fatal injury.
If the child weighs more than 48 lbs (22 kg),
only use LATCH-type (ISOFIX) child restraint
systems with which the child is also secured
with the vehicle seat belt. Also secure the
child restraint system with the Top Tether
belt, if available.
Always comply with the manufacturer's instal-
lation and operating instructions for the child
restraint system used.
Before every trip, make sure that the LATCH-
type (ISOFIX) child restraint system is engaged
correctly in both LATCH-type (ISOFIX) securing
rings
!
When installing the child restraint system,
make sure that the seat belt for the middle
seat does not get trapped. The seat belt could
otherwise be damaged.
LATCH-type (ISOFIX) securing rings ; on the
rear seats are covered by a Velcro-fastened
upholstered lining :.
Vehicles with a rear reclining seat: adjust
X
the rear reclining seat backrest down a little
61
Z