Seats
112
The supplementary cushion is in the vehicle.
The supplementary cushion is attached to the
head restraint by three press studs.
Attaching the supplementary cushion:
Position the head restraint as far forwards as
X
possible (
page 102).
Y
Hold supplementary cushion ; against the
X
head restraint and push press studs : into
the counterpieces.
Removing the supplementary cushion:
Position the head restraint as far forwards as
X
possible (
page 102).
Y
Release press studs : and remove supple-
X
mentary cushion ;.
Adjusting the rear center head
restraints
Retracting and extending electrically
Press and hold button : until the head
X
restraint has fully extended or retracted.
Folding into position mechanically
Pull the head restraint up until it engages.
X
Adjusting the active multicontour
seat
You can adjust the active multicontour seats for
the driver and front passenger via the multime-
dia system; see the Digital Operator's Manual.
The driving dynamics settings are only activated
if:
the seat is occupied
R
the seat belt is fastened
R
Adjusting the active multicontour
seat in the rear compartment
You can adjust the multicontour seats for the
outer seats in the rear using the remote control;
see the Digital Operator's Manual.
Adjusting the 4-way lumbar support
You can adjust the 4-way lumbar support via the
multimedia system (see the Digital Operator's
Manual).
Switching the seat heating on/off
Switching on/off
G
WARNING
Repeatedly switching on the seat heating can
cause the seat cushion and backrest pads to
become very hot. The health of persons with