Removing And Installing - Mercedes-Benz S-CLASS 2017 Operator's Manual

Stowage areas
288
and secure heavy objects in the trunk outside
the EASY-PACK trunk box.
The maximum permitted load of the EASY-PACK
trunk box is 22 lbs (10 kg). With a load of above
approximately 11 lbs (5 kg), the bottom of the
box moves downwards until it rests on the mat
of the trunk floor. Thus, overloading of the box is
avoided.
Adjusting the height to any position
Example
Pull the box out by handle : in the direction
X
of the arrow as far as it will go.
To lower the load surface: push down with
X
your hand in the center of load surface ; in
the direction of the arrow until load sur-
face ; has reached the desired position.
To raise the load surface: press switch =.
X
Load surface ; of the box moves up auto-
matically.
To stow the box: push the box in by han-
X
dle : as far as it will go.

Removing and installing

Example
To install: insert retainer ; of box : into
X
slots =.
Example
Raise box : and press hooks A into anchor-
X
age ? as far as they will go.
Turn left-hand rotating catch B counter-
X
clockwise and right-hand rotating catch B
clockwise by 90°.
To remove: turn left-hand rotating catch B
X
clockwise and right-hand rotating catch B
counter-clockwise by 90°.
Move box : downwards and pull it out from
X
anchorages ?.
Store the EASY-PACK trunk box on a flat surface
after removal, e.g. on a suitable shelf.
Securing loads using parcel net hooks
General notes
Observe the following notes on securing loads:
Secure the load using the parcel net hooks
R
Do not use elastic straps or nets to secure a
R
load, as these are only intended as an anti-slip
protection for light loads.
Do not route tie-downs across sharp edges or
R
corners.
Pad sharp edges for protection.
R