Advertisement
®
®
R&S
AFQ100A, R&S
The following advanced parameters are available:
●
"mDNS and DNS-SD": The additional protocols "multicast DNS" and "DNS service
discovery" are used for device communication in zero configuration networks,
working without DNS and DHCP.
●
"ICMP Ping enabled": Must be enabled to use the ping utility.
If you disable this setting, the instrument does not answer ping requests. The set-
ting does not affect the LXI ping client. You can ping other hosts from the instru-
ment, even if the setting is disabled.
●
"VXI-11 Discovery": Must be enabled to detect the instrument in the LAN.
If you disable this setting, the instrument cannot be detected by the VXI-11 discov-
ery protocol mechanism. The setting does not affect other detection mechanisms.
Setting up a VXI-11 connection via the IP address or the host name is independent
of this setting.
1.1.2.3
Ping Parameter
The "Ping Client" page provides the ping utility to verify the connection between the
LXI-compliant instrument and another device.
The ping is initiated from the instrument. Using the ICMP echo request and echo reply
packets, the function checks whether the communication with a device via LAN works.
Ping is useful for the diagnosis of IP network or router failures.
The ping utility is not password-protected.
To initiate a ping from the instrument to the device:
1. Enable "ICMP Ping" on the "Advanced LAN Configuration" page (enabled after an
LCI).
2. Select the "Ping Client" page.
3. In the "Destination Address" field, enter the IP address of the device to be pinged
(without the ping command and without any further parameters), e.g.
10.111.10.203.
4. Select "Submit".
Supplement 1175.6978.02 ─ 04
AFQ100B
LXI (R&S AFQ100B only)
LXI Configuration
7
Advertisement
