Denon AVC-A1XV Service Manual page 30

Av surround amplifier
Hide thumbs Also See for AVC-A1XV:
Table of Contents

Advertisement

ADJUSTMENT
AUDIO Section
IDLING CURRENT (1U-3637-1)
Required measurement equipment: DC Voltmeter
1. PREPARATION
(1) Avoid direct blow from an air conditioner or an electric
fan, and adjust the unit at normal room temperature 15 °C
~ 30 °C (59 °F ~ 86 °F).
(2) Presetting
• POWER (Power source switch)
• SPEAKER (Speaker terminal)
(Do not connect speaker, dummy resistor, etc.)
2. ADJUSTMENT
(1) Remove side cover and set VR101, VR201, VR301,
VR401, VR501 on 1U-3637-1 (Power Unit) at fully coun-
terclockwise (
).
(2) Connect DC Voltmeter to test points (CN103, CN203,
CN303, CN403, CN503 ① ③ pin).
(3) Connect power cord to AC Line, and turn power switch
"ON".
(4) Turn power switch "ON" with pressing [GAME] and
[SRROUND BACK] buttons in the door of front panel.
(5) Presetting.
MASTER VOLUME : "---" counterclockwise (
MODE
: 9CH STEREO
FUNCTION
: CD
(6) Allow 2 minutes, and turn VR101 clockwise (
just the TEST POINT voltage to 3.5 mV ± 0.2 mV DC.
(7) After 10 minutes from preset, turn VR101 to set the volt-
age to 4.0 mV ± 0.2 mV DC.
(8) Adjust the Variable Resistors of other channels in the
same way.
(9) After 5 minutes from (7), turn VR101 to set the voltage to
4.0 m ± 0.2 mV DC.
(10) Adjust the Variable Resistors of other channels in the
same way.
調整
オーディオセクション
アイドリング電流の調整 (1U-3637-1)
調整に必要な測定器 : DC Voltmeter
1. 準備
(1) セットをクーラ、扇風機のそばなど風通しの良い場所
を避け、通常の使用状態に置きます。セットの周囲温
度は 15 ∼ 30 ℃、湿度は常湿とします。
(2) プリセット
OFF
・電源スイッチ
No load
・スピーカー端子
( スピーカー・ダミー抵抗器などを接続しない。)
2. 調整
(1) サイドカバーをはずし、1U-3637-1(パワーユニット)
の VR101, VR201, VR301, VR401, VR501 を反時計方向
(
(2) テストポイント (CN103, CN203, CN303, CN403, CN503
の① ③ pin) に DC Voltmeter を接続します。
(3) 電源コードを AC ライン (95 ∼ 105V の範囲であること)
に接続し、電源スイッチを "ON" にします。
(4) フロントパネルのドア内にある「GAME」ボタンと
「SURROUND BACK」ボタンを押しながら電源スイッチ
を "ON" にします。
min.)
(5) ON 後、次のようにセットします。
・MASTER VOLUME(音量調節つまみ)→反時計方向
(
) to ad-
・SPEAKER(スピーカー端子)→無負荷(スピーカー、
ダミー抵抗器などを接続しない。 )
(6) 2 分以内に VR101 を時計方向 (
ントの電圧を次のように調整します。
(7) 予備調整から 10 分後 VR101 を回し、次のように電圧を
設定します。
(8) 同じ方法で各チャネルの可変抵抗を調整します。
(9) (7) 項設定から 5 分後 VR101 を回し、次のように電圧を
設定します。
(10) 同じ方法で各チャネルの可変抵抗を調整します。
30
AVR-5805/AVC-A1XV
) に回し切った状態にセットします。
) に回す、最小の状態にする。
MODE : 9CH STEREO 
FUNCTION : CD
3.5mV ± 0.2mV DC
4.0mV ± 0.2mV DC
4.0mV ± 0.2mV DC
OFF
無負荷
) に回しテストポイ

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents