Hyundai Genesis 2016 Owner's Manual page 121

Flashing
2. Position the end of your hand-held
transmitter 1-3 inches (2-8 cm)
away from the HomeLink
you wish to program while keeping
the indicator light in view.
3. Simultaneously press and hold
both the HomeLink ® and hand-
held transmitter buttons until the
HomeLink ® indicator light changes
from a slow to a rapid blinking
light. Now you may release both
the HomeLink ® and hand-held
transmitter buttons.
✽ ✽ NOTICE
Some devices may require you to
replace this Programming step 3
with procedures noted in the "Gate
Operator/Canadian Programming"
chapter. If the HomeLink
light does not change to a rapidly
blinking light after performing these
steps, contact
www.homelink.com.
4. Firmly press, hold for 5 seconds and
ODH044414N
release
®
HomeLink
rate times to activate the door. If the
®
button
door does not activate, press and
hold the just-trained HomeLink
ton and observe the indicator light.
• If the indicator light stays on con-
stantly, programming is complete
and your device should activate
when the HomeLink
pressed and released.
• If the indicator light blinks rapidly
for 2 seconds and then turns to a
constant light, continue with
"Programming" steps 5-7 to com-
plete the programming of a rolling
code equipped device (most com-
monly a garage door opener).
5. At the garage door opener receiv-
®
indicator
6. Firmly press and release the
®
HomeLink at
7. Return to the vehicle and firmly
the programmed
button up to two sepa-
® but-
®
button is
HomeLink
rolling code equipped device.
er (motor-head unit) in the garage,
locate the "learn" or "smart" but-
ton. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit.
"learn" or "smart" button. (The
name and color of the button vary
by manufacturer). There are 30
seconds to initiate step 7.
press, hold for 2 seconds and
release the programmed
HomeLink ® button. Repeat the
"press/hold/release" sequence a
second time, and, depending on
the brand of the garage door
opener (or other rolling code
equipped device), repeat this
sequence a third time to complete
the programming process.
®
should now activate your
3
3-27