Table of Contents
Advertisement
Convenient features of your vehicle
WARNING
Before programming HomeLink
to a garage door opener or gate
operator, make sure people and
objects are out of the way of the
device to prevent potential harm
or damage. Do not use the
HomeLink
®
with any garage door
opener that lacks the safety stop
and reverse features required by
U.S. federal safety standards
(this includes any garage door
opener
model
manufactured
before April 1, 1982). A garage
door that cannot detect an object
- signaling the door to stop and
reverse - does not meet current
U.S. federal safety standards.
Using a garage door opener
without these features increases
the risk of serious injury or
death.
3-26
Programming HomeLink
Please note the following:
• When programming a garage door
®
opener, it is advised to park the
vehicle outside of the garage.
• It is recommended that a new bat-
tery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink
training and accurate transmission
of the radio-frequency signal.
• Some vehicles may require the
ignition switch to be placed in the
ACC (or "Accessories") position for
programming and/or operation of
®
HomeLink
.
• In the event that there are still pro-
gramming difficulties or questions
after following the programming
steps
listed
below,
HomeLink
®
at: www.homelink.com
or by calling 1-800-355-3515.
®
Programming
®
for quicker
To train most devices, follow these
instructions:
1. For first-time programming, press
and hold the two outside buttons
(
), HomeLink
,
and Channel 3, until the indicator
contact
light begins to flash (after 10 sec-
onds). Release both buttons. Do
not hold the buttons for longer
than 20 seconds.
Flashing
ODH044413N
®
Channel 1
Advertisement
Chapters
Table of Contents
