Loop Clamp Feed Components; Adjusting The Loop Clamp Base Plate Front Sensor - JUKI MOL-254 Engineer's Manual

(2) Loop clamp feed components

1) Adjusting the loop clamp base plate front sensor

1. Operate the machine by the step operation and adjust the clearance provided between the loop
clamp base plate and the cross cut receiving portion to 1 to 2 mm when the loop clamp base plate
travels to its front end.
2. The clearance provided between the top surface of the loop clamp base plate and the loop clamp
base plate front sensor is 1±0.5 mm.
1 ± 0.5 mm
Standard Adjustment
93
− −
1 to 2 mm