Installation - Dickinson P9000 Operating And Installation Instruction

Installation

Here are some important notes to remember when installing a Dickinson
direct draft propane heater:
• Mounting & location, 12v power hook-up, minimum 20" and a
maximum 56" of chimney, the location of hole for the chimney & the
fuel supply.
• If not connecting your heater using one of Dickinson's propane hoses
then you will need to find fittings to match the heaters. The valve on
the heater has a male 3/8" flare fitting SAE, 45° flare standard gas
fitting.
• Install a separate low pressure regulator that reduces pressure to 11"
W/C
Location
When installing your new propane heater, keep in mind the location of the
heater and where it will maximize the heating capability. This propane
heater is equipped with a 12v fan that will blow hot air from the top of the
heater down to the floor.
This increases heating efficiency and provides good circulation of hot air.
Mounting the heater lower will allow for more efficient circulation of heat in
the cabin. Plan your heaters location prior to installing to ensure the location
chosen will fit the specifications and safety clearances.
9