Fcc Statement; Ec Declaration Of Conformity - Hilti PR 20 Operating Instructions Manual

12. FCC statement

(applicable in US)
- WARNING -
This equipment has been tested and has
been found to comply with the limits for a
class B digital device, pursuant to part 15
of the FCC rules.
These limits are designed to provide rea-
sonable protection against harmful interfer-
ence in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruc-
tions, may cause harmful interference to
radio communications. However, there is
no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful inter-
ference to radio or television reception,
which can be determined by turning the
equipment on and off, the user is encour-
aged to try to correct the interference by
one or more of the following measures:
– Re-orient or re-locate the receiving
antenna.
– Increase the separation between the
equipment and receiver.
– Consult the dealer or an experienced
TV / radio technician for assistance.
Changes or modifications not expressly
approved by Hilti could limit the user's
right to operate the equipment.
12
Printed: 07.07.2013 | Doc-Nr: PUB / 5070169 / 000 / 00
12. FCC statement / 13. EC conformity
Product information plate
Made in Germany
Hilti= registered trademark of the Hilti Corporation, Schaan, Liechtenstein
LASER RADIATION - DO NOT
STARE INTO BEAM
620-690nm/0.95mW max.
CLASS II LASER PRODUCT
13. EC conformity
Designation: Rotating laser
Type: PR 20
Year of design: 2003
In conformance with
We declare, on our own responsibility,
that this product complies with the follow-
ing standards or standardization docu-
ments: EN 50081-1 and EN 50082-1
according to the stipulations of the
directive 89/336/EEC.
Hilti Corporation
Matthias Gillner
Head BU
Measuring Systems
12/2004
PR 20
1/4 s
2
EN 60825-1:2003
This Laser Product
complies with 21CFR
1040 as applicable
Power: 4,5V=nom./120 mA
Dr. Heinz-Joachim Schneider
Executive Vice President
BA Electric
Tools & Accessories
12/2004