Hilti PR 20 Operating Instructions Manual page 39

– WARNING –
This equipment has been tested and has
been found to comply with the limits for a
class B digital device, pursuant to part 15
of the FCC rules. These limits are
designed to provide reasonable protection
against harmful interference in a residual
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment on and off, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
Re-orient or re-locate the receiving
–
antenna.
Increase the separation between the
–
equipment and receiver.
Consult the dealer or an experienced
–
TV / radio technician for assistance.
Changes or modifications not expressly
approved by Hilti could limit the user's
right to operate the equipment.
36
Printed: 07.07.2013 | Doc-Nr: PUB / 5070169 / 000 / 00
Hilti Corporation
Matthias Gillner
Head BU
Measuring Systems
09/2004
Dr. Heinz-Joachim Schneider
Executive Vice President
BA Electric
Tools & Accessories
09/2004