Advertisement
Operation Guide
Web browser operation guide
2.1 Common operations
Factory settings：
The IP camera is a network device , you need to configure the network IP
address, gateway and other information reasonably, camera with default IP address
in factory, user could change it according to their requirement.
Default IP address：192.168.0.99
Subnet mask：255.255.255.0
Gateway：192.168.0.1
WEB port：8000
Network parameters
Take the example of Windows XP operating system. Make sure the IP address
in network parameters of the user computer is in accordance with the one of the
camera, they are in same segment, the IP address in the same LAN can not be the
same, otherwise, it will interfere with each other, causing the equipment couldn't
operate normally.
After setting IP address, you could test whether it has been connected between
the computer and the camera by using the PING order from clicking the
"start"-"run" button in the bottom left corner. The format of the command:
ping 192.168.0.99
If the screen shows like this:
pinging 192.168.0.99 with 32 bytes of data:
Reply from 192.168.0.99: bytes=32 time<1ms TTL=64
Reply from 192.168.0.99: bytes=32 time<1ms TTL=64
Reply from 192.168.0.99: bytes=32 time<1ms TTL=64
Reply from 192.168.0.99 bytes=32 time<1ms TTL=64
ping statistics for 192.168.0.99:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
Vi-C6201
Advertisement
