Leister LE 40 000 Operating Instructions

Electric hot air tool

Table of Contents

Download this manual

OPERATING INSTRUCTIONS

LEISTER LE 40 000

Electric Hot Air Tool

Please read operating instructions carefully before use and

keep for further reference.

• The LEISTER Hot Air Tool type 40 000 is suitable for building into machines,

installations or appliances and is designed for continuous operation.

• Drying and heating processes of various types.

• Shrinking and welding packaging films and moulded parts.

• Heating conveyor ovens or heat tunnels.

• Activating and loosening solvent free adhesives and melt adhesives.

• Sterilizing packaging materials such as bottles, corks and containers.

• Separating and fusing synthethic fibres and fabrics.

• Soldering processes on thin metal parts.

• Speeding up mixing processes and dissolving foams which can arise during

mixing and filling operations.

• Removing plastic mould flash and putting a shine on plastic surfaces.

LEISTER Process Technologies, Riedstrasse, CH-6060 Sarnen / Switzerland

Tel. + 41 41 662 74 74 Fax + 41 41 662 74 16

(without electronics)

www.leister.com

sales@leister.com

Table of Contents

Do you have a question about the LE 40 000 and is the answer not in the manual?

Page 1: Operating Instructions
Please read operating instructions carefully before use and keep for further reference. APPLICATION • The LEISTER Hot Air Tool type 40 000 is suitable for building into machines, installations or appliances and is designed for continuous operation. • Drying and heating processes of various types.
Page 2 WARNING Danger! When opening up the tool, live components and connections are exposed. Therefore, before open- ing it, unplug the tool to ensure disconnection from the mains. Incorrect installation and use of hot air tools can present a fire and explosion hazard. The specified minimum air flow must be absolutely adhered to.
Page 3 Should the air flow be interrupted or the air flow fall below the minimum, the mains must be disconnected at the same time. • LEISTER blowers must be used for the air supply (pay attention to the direction of rotation and the electrical connection).
Page 4 • Make sure that the hot air can flow freely as otherwise back pressure could da- mage the tool (fire hazard). • The LEISTER Company, as well as the authorized Sales and Service Centres, offer advice and an introduction to the areas of application of hot air tools, free of charge (see page 1).