Advertisement
Remote Modem Installation Instructions
28i/124i
To test your office modem setup:
to test your office modem.
1. From the Main Menu, select Communication and press Enter.
Select Modem Control and press Enter.
2.
Type AT&F and press Enter. Your computer should echo back OK.
3.
connections and settings and repeat step 3.
Windows PC Program Only:
To set up your office modem using Windows
1. Make sure your modem is properly connected to your computer and
functioning correctly.
2. Start the HyperTerminal program. (Click START - PROGRAMS -
ACCESSORIES - HYPERTERMINAL. Double-click on the
HYPERTRM.EXE file.)
3. Create a name for the new connection, such as MODEM SETUP and
click OK.
4. Select the COM Port (1 - 4) to be used and click OK.
Set the RS232 options for: 9600 (Bits per Second), 8 (Data Bits),
5.
none (Parity), 1 (Stop Bits), None (Flow Control) then click OK.
Step 1 - Program the DCI.
6. Enter the initialization string (spaces shown for clarity):
AT E0 Q0 M1 V1 &C1 &D3 and press Enter.
5. Connecting to the Site
Now that your connection is correctly set up and tested, you can call the site
modem and program remotely from your office or program the system locally
through a PC. Also use this procedure when testing the site modem from another
modem on site.
DOS PC Program Only:
To connect to the site:
1.
Make sure your modem is correctly connected to your office computer,
an outside telephone line (or other dial tone source) and is functioning
correctly.
2. Start the Remote Maintenance program and enter your programming
password (when requested).
Never call the site modem without first using the following steps
If you don't get the proper response (OK), check your modem
Your modem can connect to COM1, COM2, COM3 or COM4.
These settings must match those you made for Program 1201 in
Your modem can only connect to COM1 or COM2.
HyperTerminal program:
8
Advertisement
