Philips H982NUD User Manual page 14

H982NUD_EN1 3/2/06 6:56 PM Page 14
14 Hookups (cont'd)
DVD/VCR to a TV and to a Stereo that is Dolby Digital-compatible
Stereo
COAXIAL
DIGITAL
AUDIO IN
1
Connect the antenna or Cable TV signal to the ANT -IN (Antenna In) jack
of your DVD/VCR.
2
Connect a coaxial digital audio cable (not supplied) to the DVD/VCR's
COAXIAL DIGITAL AUDIO OUT jack and to the COAXIAL DIGITAL
AUDIO IN jack on the Stereo.
This digital audio connection only provides sound for the DVD player of the DVD/VCR.
So, in order to use the VCR features or hear TV channels at the DVD/VCR, you still
need to either connect the RF coaxial cable between the ANT-OUT jack of the
DVD/VCR and the TV's Antenna In jack, or connect the supplied red/white audio cables.
To connect the supplied RF coaxial cable, see step 2 on page 9.To connect the red/white
audio cables, see step 2 on page 12.
3
Connect the supplied yellow video cable to the yellow DVD/VCR VIDEO
OUT jack on the DVD/VCR and to the VIDEO IN jack on the TV. To use
component video cable or S-Video cable instead for the DVD player, see
page 12.You will still need the yellow video cable or RF coaxial cable for VCR
features.
4
Plug in the power cords of the Stereo,TV and DVD/VCR.Turn on the
Stereo and select its Auxiliary IN channel.Turn on the TV and set it to
the correct Video In channel. Go to your TV's lowest channel (01 or 02) and
change channels downward until you see DVD or VCR material on the TV screen.
To help you find the right Video In channel on the TV, turn on the DVD/VCR. Press
DVD to put the DVD/VCR in DVD mode.With no disc in the player, a large DVD
Video logo will appear on the TV screen when you get the TV on the correct Video
In channel.
Make sure PROGRESSIVE is OFF and P.SCAN does not appear on the DVD/VCR's
display panel. Disable
pressing and holding PLAY B (DVD) on the front of the DVD/VCR for more
than 5 seconds. Details are on pages 8 and 54.
5
You are ready to turn on the DVD/VCR. Go to page 16 before turning on
the DVD/VCR.
Remember...
Some DVDs are recorded in Dolby Digital 5.1 channel Surround Sound. Select Dolby Digital
5.1 channel Surround Sound in the DVD disc menu. If Dolby Digital Surround Sound is not
recorded on the disc, you will not have surround sound available.
If you connect the DVD/VCR to a Dolby Digital Stereo, set DOLBY DIGITAL to
BITSTREAM in the DVD player's setup menu. Details are on page 55. If the DVD/VCR is not
connected to a Dolby Digital-compatible Stereo, set DOLBY DIGITAL to PCM.
Incorrect settings may cause noise distortion and damage the speakers.
Using Digital Audio connections
1
Antenna/Cable TV Signal
DVD
DVD/VCR VCR
DIGITAL COMPONENT
AUDIO S-VIDEO AUDIO OUT AUDIO IN
VIDEO OUT
AUDIO OUT OUT OUT
Y L L
L
C /
B
R R
P
B
COAXIAL
VIDEO OUT VIDEO IN
R
C R /
P R
2
Progressive Scan either in the DISPLAY menu or by
ANT - IN
ANT-OUT
3
Back of TV
(example only)
VIDEO IN