One-Touch Recording - Philips DVP3200V/37 User Manual

E8A21UD_EN1 5/29/06 3:13 PM Page 26

26 One-Touch Recording

One-Touch Recording (OTR) lets you set a timed recording 30
minutes to 8 hours long of the current TV channel. Before you
begin:
●
Place the DVD/VCR in VCR mode. Press VCR so VCR light
appears on the front of the DVD/VCR.
●
Select a recording speed (SP, SLP) by pressing REC MODE.
●
Put a videotape in the cassette compartment. Make sure the
tape's record tab is intact and the tape is long enough to record
the program(s).
1
Press VCR, then press CH + or CH - or the Number
buttons to select the channel you want to record.
2
Press REC
length (30 minutes to 8 hours) appears on the TV
screen. Recording will begin. "REC" and " " will appear
on the DVD/VCR's display panel.
OTR (0:30)
SP
When an OTR ends
The DVD/VCR will turn off and " " on the DVD/VCR's display
panel will flash indicating that the recording is complete, then goes
into the timer standby mode again. (It may switch to DVD mode
automatically.) At this point, you cannot use the VCR unless you
release the DVD/VCR from the timer standby mode.
To release the DVD/VCR from timer standby mode
●
If the DVD component is active and no more timer recordings
are on standby, you can cancel the timer standby mode by
pressing TIMER SET or VCR on the remote control or by
pressing SOURCE or STOP/EJECT C A on the front panel.
●
If the DVD component is not active, or the " " is not flashing
but lit indicating there are more timer recordings on standby,
you can cancel the timer standby mode only by pressing
TIMER SET on the remote control or by pressing
STOP/EJECT C A on the front panel.
●
After releasing the DVD/VCR from timer standby mode, you
can use it as usual.
Stopping an OTR
To stop an OTR before recording is finished, press STOP C on the
remote control or STOP/EJECT C A on the front of the DVD/VCR.
To cancel the OTR but continue recording, press REC
repeatedly until REC appears in the upper left corner of the TV
screen, and " " disappears.
repeatedly until the desired recording
I
1
TV/VIDEO
SUBTITLE
2
Helpful Hints
• The remaining recording time
will appear on the display panel
during an OTR. Press DISPLAY
to see it on the TV screen.
• To change the recording length
while an OTR is in progress,
press REC I repeatedly.
• You cannot pause an OTR.
• If the preset time for a timer
recording comes up during an
OTR, the OTR has priority. The
timer recording will not take
place.
• If the end of the tape is reached
during an OTR, the VCR will
stop recording, eject the tape,
and switch to DVD mode or
turn off.
• If one or more Timer
recordings are on standby when
I
one OTR ends, the DVD/VCR
will turn off automatically and
" " will appear on the
DVD/VCR's display panel
indicating that it is now ready
for another timer recording.
VCR DVD VCR Plus+
AUDIO ANGLE ZOOM
DISC/VCR DVD
MENU SETUP
OK
BACK
DISPLAY
PLAY
REW FFW
PREV PAUSE NEXT
REC STOP
1
+
REPEAT
TIMER SET
CH
REPEAT -
A-B
CLEAR