Configuring The Wireless Ethernet Adapter - Gemtek Systems WL-299 series User Manual

3 Configuring the Wireless Ethernet Adapter

The Wireless Ethernet Adapter is a ready to use device. It is delivered with default
settings which allow you to have access to it without configuring it.
You configure the Wireless Ethernet Adapter via a JavaScript-enabled web-browser such
as the Internet Explorer 4.0 or higher, or the Netscape Navigator 4.0 or higher.
The computer that you are using for initial configuration must have an IP
Address within the same range as the IP Address of the Wireless Ethernet
Adapter.
The Wireless Ethernet Adapter has a default IP Address of 192.168.5.90 with a
subnet mask of 255.255.0.0
Factory Default Settings for the Wireless Ethernet Adapter
SSID
Channel
Transmission rates
WEP enable
IP Address mode
IP Address
Subnet mask
User Name
Administrator or password
When you do configure the Wireless Ethernet Adapter, you can change the
settings with respect to security, radio channels, etc.
default
6
Auto
No
Static
192.168.5.99
255.255.0.0
Blank
Blank (no password needed)
6