Gemtek Systems WL-299 series User Manual page 16

WEP Key Length: The default Key Length is 64-bit. The WEP key is generated from
Hexadecimal entries that are either 64 or 128-bit in length.
also sometimes referred to as 40-bit or 104-bit encryption)
enabling encryption, select the Key Length, either 64 or 1
then input the Hexadecimal digits. For 64 bit keys you must
enter 10 hex digits into the key fields, for 128 bit keys you must
enter 26 hex digits. If you leave the key field blank this means a
key of all zeros.
Note: Only the following alphanumeric characters are allowed in the entry, which is 0 to 9,
a to f.
WEP Key to Use: Use the pull-down menu to select the WEP key. All devices on the
network must use the same key to communicate with one another.
Deny Unencrypted Data: For additional security when WEP is enabled, select Deny
Authentication Type. You may choose between Open System, Shared
Unencrypted Data. Data received without a WEP key is
rejected when Deny Unencrypted Data is selected.
Key, and Both. The Authentication Type default is set to
Open System. Shared Key is when both the sender and
the recipient share a secret key. All points on your network
must use the same authentication type. It is recommended
that you use the default setting.
16
(This is
When
28-bit, and