Installation - Gemtek Systems WL-299 series User Manual

2 Installation

1. Mount the Wireless Ethernet Adapter firmly on the position that is determined
during the site survey.
2. Insert the power connector.
3. Attach the Wireless Ethernet Adapter to Ethernet network by using UTP
Ethernet cable.
At the front of the Wireless Ethernet Adapter you will see three LEDs.
If all goes well, the LED (Power) is red and the (LINK) and (ACT) LEDs flash
whenever there is traffic on the respective networks.
The Wireless Ethernet Adapter automatically selects the medium attached. When
the cable network is detected, the network LED will turn yellow.
Reset the Wireless Ethernet Adapter
If you press the reset button for more than four seconds, the Wireless Ethernet Adapter
will be reset to the default factory settings. All changes you made to the configuration will
be lost.
1.Insert one end of a paperclip into the hole for the reset button and keep it pressed for
more than four seconds. After about three seconds, the ACT LED goes from constantly on
to being blinking.
2.Release the reset button when the LED has gone off. All settings are deleted. You will
need to reconfigure the Wireless Ethernet Adapter.
5