Table of Contents
Advertisement
Using the RMP-5 with Additional Pads
Parameter List
While simultaneously holding down the [METRONOME] and [COACH] buttons, turn on the power.
Afterwards, press the [COACH] button to select the parameter, then press the [+] or [-] button to set the value.
* Press the [METRONOME] button to have selections come up in the reverse order.
Parameter
Input Mode
(displayed when turning on the power)
Trigger Type
Sensitivity
Threshold
Velocity Curve
Scan Time
Retrigger Cancel
Crosstalk Cancel
Mask Time
Rim Sensitivity*
Rim Gain
You should make fine adjustments to these parameters as appropriate for your pad only if you are experiencing problems in
spite of selecting the correct trigger type.
Sensitivity
This adjustment determines the pad's response. Higher values
means higher sensitivity, and the pad will produce a loud sound
even when played softly.
Threshold
This setting allows the trigger signal to be received only if the pad is
played harder than a specified dynamic. This can be used to prevent
the pad from sounding due to extraneous vibrations from another
pad.
When set to a higher value, no sound is produced when the pad is
struck lightly.
20
Head x 2
Head&Rim
PD-8
PD-9, PD-7, PD-6
PD-85, PD-80R, PD-80
PD-105, PD-100
PD-125, PD-120
KD-8
KD-120, KD-85, KD-80, KD-7
CY-8
CY-15R, CY-14C, CY-12R/C, CY-12H, CY-6
RT-7K
RT-5S
RT-3T
— ---
1–16
0–15
,
,
,
0–4.0 ms (adjustable in increments of 0.1 ms)
1–16
, 20–80 (adjustable in increments of 5)
0–64 ms (adjustable in increments of 4 ms)
, 1–20, ---
0.5–20, ---
Value
,
,
,
,
Velocity Curve
This determines volume changes corresponding to your playing
velocity.
(Linear)
This is the normal setting and produces the most natural
correspondence between playing dynamics and changes in
volume.
,
(Exponential 1, Exponential 2)
Compared to Linear, a wider volume change will occur for
stronger hits.
Page
p. 18
p. 19
p. 20
p. 20
p. 20
p. 21
p. 21
p. 21
p. 21
p. 21
p. 21
Advertisement
Table of Contents
