Appendices; Adjusting The Pad Sensitivity; Restoring The Factory Settings; If An Error Message Appears - Roland RMP-5 Owner's Manual

Appendices

Adjusting the Pad Sensitivity

When practicing with Stroke Balance, if you think that the needle
swings too much or too little, then adjust the head sensitivity.
1.
While simultaneously holding down the
[METRONOME] and [COACH] buttons, turn on the
power.
2.
Press the [COACH] button twice.
The display shows "
3.
Press the [+] or [-] button to adjust the sensitivity.
(initial setting: 5)
Setting this to a higher value makes the sensitivity higher.
4.
When finished, press the [START/STOP] button.
The setting is stored, and then the RMP-5 returns to the
normal screen.

Restoring the Factory Settings

This restores the RMP-5 to the original factory settings.
1.
Hold down the [START/STOP] button and turn on
the power.
The display shows "
2.
Press the [START/STOP] button again and keep
pressing to restore the factory settings.
All settings are returned to the default factory settings.
When the procedure is finished, the RMP-5 returns to the
normal screen.

If an Error Message Appears

This section lists the different error messages that may appear,
along with their meanings and measures to resolve the problems
described.
Display Meaning
"
button is pressed. Press the [START/STOP]
button once again and keep pressing to
execute the Factory Reset. Only the
Data in the RMP-
settings for the corrupted portion are
5's memory may
subject to Factory Reset (doing so will erase
be corrupted.
any changes you have made).
If this does not resolve the problem,
consult your Roland dealer or nearest
Roland Service Center.
22
."
."
Action
" appears when the [START/STOP]
Display Meaning
A problem has
occurred with Consult your Roland dealer or nearest
the internal Roland Service Center.
system.

Replacing the Head

If the head has been damaged or no longer maintains correct
tension, replace it.
To order replacement heads (#04788790 RMP-3 PAD HEAD(NEW)
<EN-3308-RT>), contact the retailer from whom you purchased
the RMP-5 or the nearest Roland Service Center.
The MH-8 Mesh Head is not compatible and cannot be
used.
Replacing the Head
When replacing or tuning, use the included drum key.
1.
Remove all tuning bolts.
Gradually loosen each one in order, turning them
counterclockwise.
* Do not lose the tuning bolts.
2.
Open the case, and then remove the old head.
fig.HeadChange
3.
Place the new head in the case.
4.
Securely close the case.
5.
Attach all eight tuning bolts.
6.
Adjust the tension of the head. Refer to
"Adjusting the Head Tension" (p. 9).
Action