Replacing Ink Tanks - Canon MB2100 SERIES Online Manual

Replacing Ink Tanks

In the case of warnings or errors caused by low ink levels, messages appear on the LCD to notify you.
Respond to the message as needed.
Message Appears
Note
• If printing is faint or affected by white streaks even when there is enough ink, see
Procedure.
• For precautionary notes on handling ink tanks, see
Steps to Replace ink tanks
When needed, replace ink tanks as follows.
1. After confirming that the machine is on, open the front cover.
The ink tanks you can replace are identified on the LCD, and the print head holder (A) moves into
position for replacement of those ink tanks.
Caution
• Do not stop the moving print head holder or force it to a different position. Do not touch the print
head holder until it stops moving.
Important
• Do not remove an ink tank until a new one is prepared to be installed.
• Once you remove an ink tank, the machine will not operate until a new one is installed.
• Once you remove an ink tank, the machine will not operate even if the removed ink tank is
just reinstalled.
• The ink tanks in other positions cannot be replaced. Forcing them out may damage the machine
or cause malfunction.
• Do not touch metallic parts or other areas inside the machine.
• If you leave the front cover open for more than 60 minutes, the print head holder will move to
the right. In this case, close the front cover and open it again.
Notes on ink tanks.
195
Maintenance